Table of Contents
Advertisement
Temporary Confidential
TGP500_550_04_QG(E).book Page 13 Tuesday, February 17, 2009 4:59 PM
FCC and other information
This equipment complies with Part 68 of the FCC rules
and the requirements adopted by the ACTA. On the
bottom of this equipment is a label that contains,
among other information, a product identifier in the
format US:ACJ----------.
If requested, this number must be provided to the
telephone company.
L Registration No.............
If the equipment is causing harm to the telephone
(found on the back of the unit/KX-TGP500)
network, the telephone company may request that you
(found on the bottom of the unit/KX-TGP550)
L Ringer Equivalence No. (REN).......0.1B
disconnect the equipment until the problem is resolved.
A plug and jack used to connect this equipment to the
WHEN PROGRAMMING EMERGENCY NUMBERS
AND(OR) MAKING TEST CALLS TO EMERGENCY
premises wiring and telephone network must comply
NUMBERS:
with the applicable FCC Part 68 rules and requirements
1) Remain on the line and briefly explain to the
adopted by the ACTA. A compliant telephone cord and
dispatcher the reason for the call.
modular plug is provided with the product. It is
2) Perform such activities in the off-peak hours, such
designed to be connected to a compatible modular jack
as early morning or late evenings.
that is also compliant.
This device complies with Part 15 of the FCC Rules.
The REN is used to determine the number of devices
Operation is subject to the following two conditions:
that may be connected to a telephone line. Excessive
(1) This device may not cause harmful interference,
RENs on a telephone line may result in the devices not
and (2) this device must accept any interference
ringing in response to an incoming call. In most but not
received, including interference that may cause
all areas, the sum of RENs should not exceed five
undesired operation.
(5.0). To be certain of the number of devices that may
Privacy of communications may not be ensured when
be connected to a line, as determined by the total
using this phone.
RENs, contact the local telephone company. For
products approved after July 23, 2001, the REN for the
CAUTION:
product is part of the product identifier that has the
To assure continued compliance with FCC rules, do not
format US:AAAEQ##TXXXX. The digits represented by
make any unauthorized changes or modifications to this
## are the REN without a decimal point (e.g., 03 is a
equipment would void the user's authority to operate this
REN of 0.3).
device.
If this equipment causes harm to the telephone
NOTE:
network, the telephone company will notify you in
This equipment has been tested and found to comply
advance that temporary discontinuance of service may
with the limits for a Class B digital device, pursuant to
be required. But if advance notice isn't practical, the
Part 15 of the FCC Rules. These limits are designed to
telephone company will notify the customer as soon as
provide reasonable protection against harmful
possible. Also, you will be advised of your right to file a
interference in a residential installation. This
complaint with the FCC if you believe it is necessary.
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
The telephone company may make changes in its
accordance with the instructions, may cause harmful
facilities, equipment, operations or procedures that
interference to radio communications. However, there is
could affect the operation of the equipment. If this
no guarantee that interference will not occur in a
happens the telephone company will provide advance
particular installation. If this equipment does cause
notice in order for you to make necessary modifications
harmful interference to radio or television reception,
to maintain uninterrupted service.
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
If trouble is experienced with this equipment, for repair
interference by one or more of the following measures:
or warranty information, please contact a Factory
– Reorient or relocate the receiving antenna.
Service Center or other Authorized Servicer. If the
– Increase the separation between the equipment and
equipment is causing harm to the telephone network,
receiver.
the telephone company may request that you
– Connect the equipment into an outlet on a circuit
disconnect the equipment until the problem is resolved.
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Useful Information
FCC RF Exposure Warning:
Connection to party line service is subject to state
L This product complies with FCC radiation exposure
tariffs. Contact the state public utility commission,
public service commission or corporation commission
limits set forth for an uncontrolled environment.
L To comply with FCC RF exposure requirements, the
for information.
base unit must be installed and operated 20 cm (8
If your home has specially wired alarm equipment
inches) or more between the product and all person's
connected to the telephone line, ensure the installation
body (excluding extremities of hands, wrist and feet).
L This product may not be collocated or operated in
of this equipment does not disable your alarm
equipment. If you have questions about what will
conjunction with any other antenna or transmitter.
L The handset may be carried and operated with only
disable alarm equipment, consult your telephone
For body-worn operation, the handset must be used
For body-worn operation, the handset must be used
company or a qualified installer.
only with a non-metallic accessory. Use of other
only with a non-metallic accessory. Use of other
the specific provided belt-clip. Other non-tested belt-
accessories may not ensure compliance with FCC
accessories may not ensure compliance with FCC
clips or similar body-worn accessories may not
This equipment is hearing aid compatible as defined
RF exposure requirements.
RF exposure requirements.
comply and must be avoided.
by the FCC in 47 CFR Section 68.316.
Notice
L FCC ID can be found inside the battery compartment
When you hold the phone to your ear, noise might be
heard in your Hearing Aid. Some Hearing Aids are not
or on the back/bottom of the units.
adequately shielded from external RF (radio
frequency) energy. If noise occurs, use an optional
FCC Declaration of Conformity
headset accessory or the speakerphone option (if
Trade Name: Panasonic
applicable) when using this phone. Consult with your
Model Number: KX-TGP500/KX-TGP550
audiologist or Hearing Aid manufacturer about the
Responsible Party: Panasonic Corporation of North America
availability of Hearing Aids which provide adequate
One Panasonic Way
shielding to RF energy commonly emitted by digital
Secaucus, NJ 07094 U.S.A.
devices.
Telephone No.: 1-800-211-PANA (7262)
WHEN PROGRAMMING EMERGENCY NUMBERS
This telephone provides magnetic coupling for hearing aids.
AND(OR) MAKING TEST CALLS TO EMERGENCY
NUMBERS:
1) Remain on the line and briefly explain to the
dispatcher the reason for the call.
2) Perform such activities in the off-peak hours, such
as early morning or late evenings.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Privacy of communications may not be ensured when
using this phone.
CAUTION:
Any changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate this device.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
13
Advertisement
Table of Contents
