3.1
Main body section
3.1.1 Removing the rear cover
(See Figs.1 and 2)
(1) From the back side of the main body, remove the fifteen
screws A attaching the rear cover. (See Fig.1.)
(2) Remove the two screws B attaching the fan cover. (See
Fig.1.)
(3) Remove the rear cover and disconnect the power cord
from the connector
CN900
the main body. (See Fig.2.)
(4) Remove the strain relief in the direction of the arrow. (See
Fig.2.)
Reference :
Before attaching the rear cover, pass the power cord through
the guide hole a on the rear cover. (See Fig.2.)
1-8 (No.MB004)
SECTION 3
DISASSEMBLY
on the power supply board of
A
B
A
Fan cover
B
Fig.1
Fuse
CN900
Fuse clip
Fig.2
A
A
A
Rear cover
Strain
relief
Power
supply
board
Power cord
Rear cover
Gurde hole a