Toshiba MMD-AP0726HP-E Service Manual page 48

Check code clearing function
How to clear the check code using the wired remote controller
Clearing an check code of the outdoor unit
Clear the currently detected outdoor unit for each refrigerant line to which the indoor
unit controlled by the remote controller is connected. (The indoor unit check code is
not cleared.) Use the service monitoring function of the remote controller.
1
Push and hold the
mode.
2
TEMP.
Push the
3
The display in A of the following figure counts down as follows at 5-second intervals:
0005 0005 0005 0004 0004 0004
0005 0005 0004 0004
" → → → → → "
"
The check code is cleared when "
However, the display counts down from "
4
Push the to return the display to normal.
Clearing an check code of the indoor unit
Push the
ON / OFF
(Only the check code of the indoor unit controlled by the remote controller will be
cleared.)
AMP Air Conditioning
CL
, and for 4 seconds or longer to enter the service monitoring
button to set CODE No. to "FF".
0003 0003 0003 0002 0002 0002
0003 0003 0002 0002
" → → → → → " " → → → → → "
0000 0000
0000 0000 0000
" appears.
0005 0005 0005
0005 0005
3
TEMP.
2
FILTER
RESET TEST
4
button on the remote controller.
0001 0001 0001 0000 0000 0000
0001 0001 0000 0000
" → → → → → " " → → → → → "
" again.
ON / OFF
TIMER SET FAN MODE
TIME SAVE VENT
SET CL SWING/FIX UNIT LOUVER
– 48 –
www.ampair.co.uk | sales@ampair.co.uk
".
1