Thermostat Configuration; Setting System Type Using Thermostat Keypad - Pelican TS200 Installation Manual

Thermostat Configuration

All configuration settings are made Online through the Pelican Web App. Each
thermostat will automatically join the Pelican Web App and will be listed both as a
notification and as a new thermostat under Admin. The thermostat is intially listed by
it's serial number. Most configurable items can be left at their default settings. For
proper operation it is necessary to set the correct System Type (Conventional or
Heat Pump). If the Web App is not accessable, the thermostat's System Type can be
set directly using the thermostat front keypad.
Inside Front Cover of Thermostat
Pelican Wireless Systems
Model No: TS200
Serial No: 2S4-A71U

Setting System Type Using Thermostat Keypad

The thermostat can be placed into the correct system type (conventional or heat
pump) during the first minute after the unit has been powered on. If the thermostat
has been running for longer than one minute, remove the front cover of the
thermostat from the rear base and then re-attach. This will cause it to recycle the
power.
Within the first minute of the thermostat powered on, press and hold the up and
down arrows simultaneously for five seconds. This will place the thermostat in
configuration mode and the display will change to show one of the three possible
system type settings:
Conventional System (Default)
Heat Pump
"W" Terminal Controls Reversing Valve.
Energized for Cool.
Heat Pump
"W" Terminal Controls Reversing Valve.
Energized for Heat.
The system type can be changed by pressing the up arrow on the thermostat.
Once the correct setting is displayed, press any other button, the thermostat will
save the setting and return to normal operation.
Pelican Wireless Systems. All Rights Reserved.
Thermostat Serial Number
Phone: 888-512-0490
Bottom of Thermostat
2S4-A71U
Website: www.pelicanwireless.com
37-0005