Makita UM600D Instruction Manual page 14

6. Turn the shear blades upside down and install
them so that the pin on the tool fits in the hole on the
shear blades. Insert the claw of the base plate into the
groove on the tool. Make sure that the shear blades are
fixed securely in place.
► 1 . Claw
7. Tighten the two screws firmly with a screwdriver.
1
► 1 . Screws
8. Place the undercover so that
cover is aligned with
1
on the under-
on the lock lever.
9. While pressing the undercover, turn it clockwise
until on the undercover is aligned with
lever.
10. Make sure that the lock lever fits in the groove on
the undercover.
1
► 1 . Lock lever
CAUTION:
Never use the tool without install-
ing the undercover.
11. Remove the blade cover, and then turn on the tool
to check that it works properly.
NOTICE:
If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
14 ENGLISH
on the lock