Installation - Yellowtec iXm Installation Instructions Manual

iXm USB Connections & Software
iXm supports two different USB connection modes if used with your computer. One is the so
called Storage Mode which enables you to exchange files (e.g. your recordings) between your
computer and iXm. The other mode is the so called Configuration Mode which you can use to
configure and monitor your iXm with the help of the Yellowtec iXm Admin and User Software.
This document shows you:
- How to enter Storage Mode
- How to enter Configuration Mode
How to install Admin and User Software
-
Storage Mode
Turn your iXm on and plug-in the USB cable to establish a physical connection between the
device and your computer. The MEM indicator will light up solid yellow indicating that you
have entered iXm's Storage Mode. Additionally, the BAT indicator will start blinking to indicate
that the built-in battery will be charged.
For copying files to your computer you don't need additional software. Just open the
Windows Explorer or the Apple Finder. You will find iXm's SD memory card as external flash
memory drive on your operating system. Audio files stored on your iXm's SD card can now be
saved to the computer. Files can be deleted anytime even with set write protection.
Configuration Mode
If you want to configure your iXm via software, you will need to enter Configuration Mode.
After turning iXm on, press and hold the FWD and STOP buttons on the playback keypad to
enter Configuration Mode indicated by a red MEM LED. Now establish a physical USB
connection between the device and your computer.
Record Keypad
Admin and User Software will be needed for configuration as well as for status monitoring.
Both are part of the iXm's scope of delivery.
After using the software just physically disconnect iXm from your computer to release iXm's
Configuration Mode. The red MEM indicator will switch off, and the iXm will enter normal
operation mode after a short memory check.
iXm USB Connections and Software Installation. Changes reserved. Yellowtec 04/2017

Installation

Playback Keypad
STOP FWD