Pairing - Plantronics Pulsar 590 Manual

PAIRING

PAIRING WITH BLUETOOTH
2 2
While pressing call control button, (1)
power headset on. (2)
7
DEVICE
®
B
590
Plantronics
3 3
4 4
0000
Headset Passkey
1. While headset indicator light is
flashing red and blue, navigate
®
to the Bluetooth discovery
screen on your device.
2. Place device in Discovery mode.
3. Select "590 Plantronics." (3)
4. When asked for passkey, enter
0000. (4)
PAIRING
PAIRING HEADSET WITH UNIVERSAL
ADAPTER (PULSAR 590A ONLY)
2 2
NOTE: The Pulsar headset is paired with the universal adapter at the factory.
However, after powering on, if adapter and headset flash red, rather than blue,
you may need to connect or pair them again. To reconnect, simply press the
adapter pairing/connect button. To pair again, follow directions below.
While pressing call control button, (1)
power headset on. (2)
B
2 2
1 1
While headset is flashing red and blue:
1. Power adapter on.
2. Press and hold the adapter pairing/
connect button for 5-7 seconds until
the adapter is flashing red and blue,
then release the button.
Headset and adapter will flash blue
when paired successfully.
8