Lincoln Electric PF40 Operator's Manual page 10

Wire Spool Type S200 Loading
WARNING
Turn the input power OFF at the welding power source
before installation or changing a wire spool.
Figure 6.

Turn the input power OFF.

Open the spool wire case.

Unscrew the Locking Nut [18] and remove it from
the Spindle [20].

Place the adapter of spool type S200 [22] on the
spindle [20] making certain the spindle brake pin
[21] is put in the hole in back side of the adapter
[22]. The adapter of spool type S200 can be
purchased separately (see "Accessories" chapter).

Place the spool type S200 [24] on the spindle [20]
making certain that the adapter brake pin [23] is put
in the hole in the back side of the spool.
WARNING
Position the spool type S200 so that it will rotate in a
direction when feeding so as to be de-reeled from
bottom of the spool.

Re-install the locking nut [18]. Make sure that the
locking nut is tightened.
English
21
20
22
23
24 18
7
Wire Spool Type B300 Loading
WARNING
Turn the input power OFF at the welding power source
before installation or changing a wire spool.
Figure 7.

Turn the input power OFF.

Open the spool wire case.

Unscrew the Locking Nut [18] and remove it from
the spindle [20].

Place the adapter of spool type B300 [25] on the
spindle [20].Make certain that the spindle brake pin
[21] is put in the hole in the back side of the adapter.
The adapter of spool type B300 can be purchased
separately (see "Accessories" chapter).

Re-install the locking nut [18]. Make sure that the
locking nut is tightened.
Figure 8.

Rotate the spindle and adapter so the retaining
spring [26] is at the 12 o'clock position.

Place the spool type B300 [28] on the adapter [25].
Set one of the B300 inside cage wires [29] on the
slot [27] in the retaining spring tab [26] and slide the
spool onto the adapter.
WARNING
Position the spool type B300 so that it will rotate in a
direction when feeding so as to be de-reeled from
bottom of the spool.
21
20
25
26 18
27
26
25 28 29
English