Table of Contents
Advertisement
Connections provided for energy control
This appliance is designed for an external energy con-
sumption control.
11
12
Fig. 9
Connect the energy peak controller across terminals
11 and 12.
CAUTION
!
A normally open (n.o.) contact of the
controller must be connected across ter-
minals 11 and 12. When this contact
closes the boiler heating elements are
disconnected. Using the dishwasher in
these conditions may increase the cycle
time.
Safety devices
•
An automatic reset thermal over-heat device incor-
porated in the windings of the electric pump cuts off
the electricity supply in the case of malfunctioning.
•
In the event of water mains failure, a device pre-
vents water in the boiler from returning into the
mains.
•
An overflow pipe, connected to the drainage outlet,
maintains the water in the tank at a constant level.
•
If any object/part of the body comes into contact
with the edge of the hood while it is lowering, a
device stops the hood and raises it again.
CAUTION
!
After installation of the appliance, check
the correct sequence of phases L1, L2,
L3. If this is not correct, alarm code "B3"
will appear on the display.
Failure to comply with safety rules and regulations
relieves the manufacturer of all liability.
B3
WARNING MESSAGES DISPLAYED ON THE
CONTROL PANEL
A1
NO WATER
-
Check that the cock is open
-
Check that the water inlet filter is clean
-
Check the minimum mains pressure
-
Check that the overflow pipe is inserted
B1
INEFFICIENT DRAINAGE
-
Check if the overflow has been removed.
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
B2
TANK WATER LEVEL TOO HIGH
-
Check for obstruction on the waste outlet pipe and
the overflow aperture.
B3
C1..C9
CALL THE SERVICE CENTRE
E1..E8
CALL THE SERVICE CENTRE
-
The appliance continues to operate, but appropri-
ate checks by a technician are recommended.
B4
DETERGENT/RINSE-AID DISPENSERS AND
SETTING
If the appliance is connected to a water softener or
osmotic device, contact the detergent supplier for a
specific product.
Peristaltic dispensers (rinse-aid and detergent) require
periodic maintenance. The internal hose of the rinse-
aid dispenser should undergo periodic maintenance
(at least once or twice a year).
Electrical connections for automatic detergent and
rinse-aid dispensers
Terminals are available on the power supply terminal
board for the electrical connection of external dispens-
ers working at 220...240 V. Max. power 30 VA.
Fig. 10
•
Connect the detergent dispenser between termi-
nals 7 and 9. These connection points are live for a
set time during filling of the tank and at the start of
the wash cycle (see paragraph "Setting the dis-
pensers").
Fig. 11
•
Connect the rinse-aid dispenser between termi-
nals 8 and 9. These connection points are live dur-
ing filling of the tank and at the end of the rinse
cycle for a set time (see "setting the dispensers"
paragraph).
9
Hide quick links:
Advertisement
Table of Contents
