Table of Contents
Advertisement
the household phone to a specific cell phone, and the cell phone will be out of state when the system is active, you still
program only the 7 digits. NOTE: This may not apply if the cell phone is outside of the country.
Even though there are 4 locations for telephone numbers, you are only required to program one telephone number.
You can program the same number in all four locations if desired. When satisfied with all of the telephone number
programming, press the Esc key to return to the previous menu.
You cannot program the phone number of the location where the THP401 is connected to, unless there are multiple
phone numbers in the building phone system (multi-line system).
NOTE: It is strongly recommended that you do not enter "911" as a telephone number, as any dial outs using
the THP401 to 911 are not considered emergencies of this caliber.
The numbers you program are your own responsibility, and should be numbers to only people such as
yourself and others that have agreed to accept phone calls from this system.
3. Alarm Low Temperature: From the main programming menu, scroll down to (3.) Alarm Low Temp and press
the Data Enter key.
The Alarm Low Temp setting is the low temperature you set for monitoring the failure of heating systems. If the
internal temperature of the THP401 (shown on the display) drops to the programmed temperature, the alert will be
triggered. Outgoing telephone calls will begin immediately when a low temperature is detected.
Press the number keys to select a preferred low temperature number, press the Esc key to delete a number, press the
Data Enter key to save the temperature. Press the Esc key to exit the programming menu, or scroll through other
options if additional programming is desired.
Important Programming Notes:
PROGRAMMING TIMEOUT DELAY = 3 MINUTES. While in programming menus, if no keys are pressed and no
selections are made within any 3 minute time period, the system will revert back to the default screen (HOME). Anytime
any key on the keypad is pushed, the backlit display will light up and allow scrolling through menus, selection and entry.
MUST BE IN "HOME" MODE TO PROGRAM: If programming (holding the * star key) is attempted while the THP401 is
in AWAY mode, a message will appear that says "Please Disarm". This message will not change until the system is
disarmed (changed back to HOME mode) by holding the # key, and entering the 4-digit Password.
RESET THE PASSWORD: If the system is armed (AWAY) there is no way to disarm the system using the keypad if you
do not have, or have forgotten, the password. If the password is forgotten while the system is in AWAY mode, the wall
power plug and the battery pack must be disconnected. Disconnecting both sources of power will reset the system back
to HOME mode (disarmed). The password is visible and can be changed from the programming menu at any time when
the system is in HOME mode.
DON'T WORRY ABOUT LOSING TELEPHONE NUMBER MEMORY: THP401 has non-volatile memory, meaning any
programming you have saved will not be deleted even with all power removed. However if the battery and wall plug are
both disconnected for a time period greater than 15 minutes, the date and time must be reset, but not the telephone
numbers or any other settings.
6
Advertisement
Table of Contents
