Table of Contents
Advertisement
Command Setting page:
In "Command Setting" page, "RS232 Config" can select COM port and baud rate.
For MTK project, please select 115200 baud rare.
After you select the COM port, you can press
In right hand checkbox,
1.
Write-EEPROM command format is 58 E0 number high_addr low_addr data1 data. . . data_number.
2.
Read-EEPROM command format is 58 E1 high_addr low_addr number. Then TV set will send data1 data2... data_number.
Maximum number of data is 8.
One other checkbox,
command
(TV set not yet ready 2006-11-15)
Barcode page:
8. Alignments
button to test whether it is available or not.
, if TV set is support E0, E1 command:
, if this setting checked, when finishes writing HDCP key process, program will send exit-factory
TPM1.0U LA
87
Hide quick links:
Advertisement
Table of Contents
