Write Mtk_Csm_Hdcp And Write Mtkhdcpkey Instructions - Philips 26MF337B/27 Service Manual

8.4 WriteMTK_CSM_No_HDCP and WriteMTKHDCPKey Instructions
WriteMTK_CSM_No_HDCP
Use USB port connecting PC & MT537x Board via ISP board.
Use Desktop PC or
Notebook USB Port
USB Cable
Introduction
Before running program, computer needs to install "Microsoft .NET framework 2.0" or later version, you can access
http://www.microsoft.com/downloads/details.aspx?FamilyID=0856eacb-4362-4b0d-8edd-aab15c5e04f5&DisplayLang=en
language for downloading.
Then, it needs following file to run WriteMTK_CSM_No_HDCP program:
1. WriteMTK_CSM_No_HDCP.exe
2. WriteMTK_CSM_No_HDCP.ini
3. FactoryCommand.ini
After run the program, WriteMTK_CSM_No_HDCP it will show below:
There are four buttons:
1. Perform writing "Set type" and "Production Code" to EEPROM
2. Configure some settings, e.g. RS232 COM port, EEPROM address
3. Send factory command
4. Exit factory
Running sequences
After pressing
8. Alignments
Instructions(write Project name and S/N)
F3 ISP Board
(USB to RS232)
RS232 Cable
MT537x
Board
program
Config saved file
Enter factory mode command
Com port and baud rate
Yellow color means port is close
Green color means port open
button, you start to scan Model Number (Set Type) and Serial Number (Production Code) barcode strings:
TPM1.0U LA
To PC USB Port
To System Board Service Port
81
and select the