Sony EVI-370 series Instruction Manual page 20

EVI-370 series
OUTLINE OF FUNCTIONS
Position Preset
All products within the EVI-370/371 series incorporate 6 presets each of which can be programmed with specific camera
settings. Using this function, zoom position, focus (auto/manual position), white balance, shutter speed, and bright control
(iris/gain) can be stored. In addition the electronic zoom position can be stored on the EVI-370D/371D/370DG/371DG.
Using Position Preset with the FK-69 board (Optional)
Preset method
When the camera has been set to the desired state press the relevant position number whilst pressing the pressing the preset
button to store the setting.
Drive method
When the desired position number button is pressed the previously stored settings will be recalled. If the desired position
number has not been programmed with desired setting the factory preset state will be recalled.
Reset method
To restore the desired position number back to the factory preset state press the relevant position number whilst pressing
the reset button.
Checking method
To check status of the six position presets, press either the reset or preset key. If the associated LED illuminates the
position number has been preset, if not, factory settings are currently stored.
Factory Preset
Normally the six position presets contain factory defaults which are temporarily written over using the preset method
outlined above. However, if the lithium battery is turned off and power is removed from the camera the factory defaults will
be reinstated. The factory defaults can be changed if required using the factory preset function which means that customers
desired settings can be stored without the need for battery backup.
Factory preset needs a control software.
NOTE : Changes to the factory preset will invalidate camera warranty.
18