Part Names - Pioneer VSX-932 Basic Manual

> Before Start > Part Names

Part Names

Part Names


Front Panel
1. INPUT SELECTOR dial: Switch the input to be played.
2. MCACC indicator: This lights when you have enabled the speaker calibration made with
MCACC (P21).
3. FL OFF indicator: This lights when you have pressed DIMMER repeatedly to turn the
display off.
4. DIMMER button: You can switch the display off or adjust the brightness of the display in
three steps.
5. TUNING MODE button: Switches tuning to an AM/FM station between automatic tuning
and manual tuning.
6. +FAVORITE button: Used to register AM/FM radio stations.
7. HOME MENU button: Displays the Home. (*)
8. Display (P4)
> Install > Initial Setup
     
 
> Playback
    
  
/  /
9. Cursor buttons ( /
press ENTER to confirm. Use them to tune to stations when using TUNER (P26).
10.NETWORK indicator: This lights when "NET" is selected with the input selector and the
unit is connected to the network. If the unit is in standby mode, this lights when functions
such as HDMI CEC and network standby are enabled.
11. WIRELESS indicator: Lights when the unit is connected to the wireless network.
12.Remote control sensor: Receives signals from the remote controller.
0 The signal range of the remote controller is within about 16´/5 m, at an angle of 20° on
the perpendicular axis and 30° to either side.
13.RETURN button: Returns the display to the previous state.
14.MASTER VOLUME
15.Í STANDBY/ON button
16.PHONES jack: Headphones with a standard plug (Ø1/4"/6.3 mm) are connected.
17.MCACC SETUP MIC jack: The supplied speaker setup microphone is connected.
> Advanced Manual
Troubleshooting | Supplementary Information, etc.
 
 
) and ENTER button: Select the item with the cursors and
3