Pioneer VSX-932 Basic Manual page 15

> Before Start > Part Names
a Speaker cable
> Install > Initial Setup
1/2˝
(12 mm)
a
> Playback > Advanced Manual
Troubleshooting | Supplementary Information, etc.
Connecting with Bi-Amping Speakers (Page 12)
0 Refer to "Standard Connections (Pages 8 to 11)" (P14) to
connect the center speaker, surround speakers, and
powered subwoofer.
Make sure you remove the jumper bar fitted between the woofer
jacks and tweeter jacks of the front speakers. Make correct
connection between the unit's jacks and speaker's jacks (+ to +
and – to –) for each channel. If connection is wrong, reverse
phase may make bass output poor. Also refer to the instruction
manual for your speakers when using connections for bi-amping.
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. Full Auto
MCACC" in Initial Setup (P21).
0 If any of the connected speakers have an
impedance of 4 Ω or more to less than 6 Ω, after
completing Initial Setup, you need to make some
settings in the System Setup menu. Press
the remote controller, and in the Home displayed
set "System Setup" - "Speaker" - "Configuration" -
"Speaker Impedance" to "4ohms".
For high-
frequency
For low-
frequency
Make sure the exposed wires of the speakers do
not stick out of the speaker terminals when
connecting. If the exposed wires of the speakers
touch the rear panel or the + and – wires touch
each other, the protection circuit will be activated.
on
15