Operation - Makita DCL182 Instruction Manual

Dust bag and paper pack
Install either dust bag or paper pack before using cleaner.
Use the dust stopper when installing either dust bag or
paper pack.
Dust bag are usable many times repeatedly by cleaning
it out.
Paper pack is a throw-away type. Throw away the entire
paper pack without emptying when it has become full.
Installing dust bag
Fig.10
Use the dust stopper when installing dust bag. Be
careful not to take the upper side for the lower side by
mistake because they are different each other.
Fig.11
1. Insert the protrusion of the dust bag into the
groove in the dust stopper as shown in the figure.
Fig.12
2. There is no distinction between the upper and
lower sides of the dust bag. You may insert its
protrusion of any side into the lower groove of the
dust stopper.
Fig.13
3. Overlap the frame of dust stopper with that of the
dust bag.
Fig.14
4. Place the dust stopper and the dust bag together
into the cleaner cavity in the same direction of
arrow on the dust stopper. Insert them all the way
into the slots in the cleaner cavity.
Fig.15
5. Place the entire cloth part of the dust bag inside
the tool itself.
Fig.16
6. Close the front cover completely.
Installing the paper pack
Fig.17
1. Unfold the entrance of the paper pack before
setting it on the dust stopper.
Fig.18
Use the dust stopper also when installing dust pack. Be
careful not to take the upper side for the lower side by
mistake because they are different each other.
Fig.19
2. Insert the protrusion of the dust pack into the
groove in the dust stopper as shown in the figure.
Fig.20
3. There is no distinction between the upper and
lower sides of the dust pack. You may insert its
protrusion of any side into the lower groove of the
dust stopper.
Fig.21
4. Overlap the frame of dust stopper with that of the
dust pack.
Fig.22
5. Place the dust stopper and the dust pack together
into the cleaner cavity in the same direction of
arrow on the dust stopper. Insert them all the way
into the slots in the cleaner cavity.
Fig.23
6. Place the entire container part of the dust pack
inside the tool itself.
7. Close the front cover completely.
CAUTION:
Forgetting to install the dust bag or the dust pack,
•
failure to insert the dust stopper together with the
dust bag or the dust pack all the way into the slots
or using a broken or ripped bag, may allow dust to
get into the motor. This may result in motor failure.
Do not fold the cardboard at its opening when
•
installing the paper pack, .
Never throw away the dust stopper because it
•
need to be used repeatedly whenever either the
dust bag or the dust pack is used.
The paper pack for the cleaner is an important
•
component for maintaining the tool performance.
Using other than the genuine paper pack may
cause smokes or ignition.

OPERATION

CAUTION:
To connect attachments, such as nozzle, twist-insert
•
attachment in direction of arrow to ensure secure
connection during use. To disconnect attachment,
twist-extract also in direction of arrow.
Fig.24
Cleaning (Suction)
Nozzle
Attach the nozzle to clean off tables, desks, furniture, etc.
Nozzle slips on easily.
Fig.25
Nozzle + Extension wand (Straight pipe)
The extension wand fits in between the nozzle and the
cleaner itself. This arrangement is convenient for
cleaning a floor while standing erect.
Fig.26
Corner nozzle
Fit on the corner nozzle for cleaning corners and
crevices of a car or furniture.
Fig.27
Corner nozzle +Extension wand (Straight pipe)
In tight quarters where the cleaner itself cannot squeeze
in, or in high places hard to reach, use this arrangement.
Fig.28
Cleaning without nozzle
You can pick up powder and dust without nozzle.
8