Radio Reception; Tuning To Radio Stations; Programming Radio Stations - Philips MC-200 Manual

Radio Reception

TUNER
TUNER
STANDBY
ON
SELECT
SOURCE
DBB DSC
INTERACTIVE SOUND
iR SENSOR
STOP PRESET
REPEAT TUNING RECORD
REV MODE
BAND
PREV

Tuning to radio stations

1
Select TUNER source.
TUNER is displayed briefly.
2
Press BAND once or more to select your
waveband.
3
Press down on TUNING à or á and release
button.
The radio automatically tunes to a station
with sufficient reception. Display indication during
automatic tuning: SEARCH.
If a FM station is received in stereo,
shown.
4
Repeat step 3 if necessary until you find the
desired station.
To tune to a weak station, press TUNING à
or á briefly and repeatedly until you have
found optimal reception.
14
pg 001-022/MC200/22-Eng
PROGRAM
TIMER
PROGRAM
TIMER
ON•OFF
INCREDIBLE SURR.
VOLUME
PLAY•PAUSE
RDS
CLOCK
TUNING
SHUFFLE
SIDE A/B
NEXT
is
STEREO
14

Programming radio stations

You can store up to a total of 40 radio stations
in the memory.
Automatic programming
Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden. The system will only programme
stations which are not in the memory already.
1 Press PRESET 4 or 3 (on the remote control
¡ or ™ ) to select the preset number where
programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROGRAM for more than 2 seconds to
activate programming.
AUTO is displayed and available stations are
programmed in order of waveband reception
strength: FM followed by MW and LW. The last
preset automatically stored will then be played.
Manual programming
1
Tune to your desired station (see "Tuning to
radio stations").
2
Press PROGRAM to activate programming.
flashes in the display.
PROGRAM
3 Press PRESET 4 or 3 (on the remote control
¡ or ™ ) to allocate a number from 1 to 40 to
this station.
4
Press PROGRAM again to confirm the setting.
disappears, the preset number and
PROGRAM
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
You can override a preset station by storing
another frequency in its place.
10/5/01, 4:25 PM
3140 115 28691