Resetting The Nbg318S; Procedure To Use The Reset Button; Navigating The Web Configurator; The Status Screen - ZyXEL Communications NBG318S User Manual

Powerline ethernet series

Hide thumbs Also See for NBG318S:

Table of Contents

3.3 Resetting the NBG318S

If you forget your password or cannot access the web configurator, you will need to use the

RESET button at the back of the NBG318S to reload the factory-default configuration file.

This means that you will lose all configurations that you had previously saved, and the

password will be reset to "1234".

1 Make sure the PWR LED is on.

2 Press the RESET button for ten seconds or until the PWR LED begins to blink and then

release it. When the PWR LED begins to blink, the defaults have been restored and the

NBG318S restarts.

The following summarizes how to navigate the web configurator from the Status screen.

The following screen displays when you log into the NBG318S.

Not all fields are available when you select Basic mode (see

page

43). See the Configuration Mode field in the System Status box to

check whether you are in Basic or Advanced mode. Use the Config Mode >

General screen to change between modes.

NBG318S User's Guide

Chapter 3 Introducing the Web Configurator

Section 3.2 on

Table of Contents

Table of Contents