Evi Configuration Examples; Evi Network Configuration Example - HP FlexFabric 12900 Series Configuration Manual

Task
Display remote MAC addresses (in IRF
mode).
Clear data for EVI IS-IS processes.

EVI configuration examples

EVI network configuration example

Network requirements
As shown in
2 network, and extend VLAN 21 to VLAN 100 across the sites.
Use network ID 1 to identify the EVI network.
Use Switch A as an ENDS and all other edge switches as ENDCs for neighbor discovery.
Figure 6 Network diagram
Configuration procedure
This example assumes that routes have been configured for the sites to reach each other.
1. Configure Switch A:
# Enable MAC address learning at the ingress.
<SwitchA> system-view
[SwitchA] mac-address mac-learning ingress
# Configure the site ID.
[SwitchA] evi site-id 1
Figure 6, use EVI to connect site 1, site 2, and site 3 across an IP network into a large Layer
Command
display evi mac-address interface tunnel interface-number [ vlan
vlan-id ] [ chassis chassis-number slot slot-number ] [ count ]
display evi mac-address interface tunnel interface-number
mac-address mac-address vlan vlan-id [ chassis chassis-number slot
slot-number ]
reset evi isis all [ process-id ]
21