Manual Preset Programming; Tuning To Preset Radio Stations; Erasing A Preset Radio Station; Changing Tuning Grid - Philips FW-V330 User Manual

Manual Preset Programming

1
Tune to your desired radio station (refer to
"Tuning to radio stations").
2
Press PROG.
➜
starts flashing.
PROG
➜ The next available preset number is displayed
for selection.
To store the radio station to another
preset number
G Press í or ë to select the desired preset
number.
3
Press PROG again to store the radio station.
➜
disappears.
PROG
G Repeat steps 1–3 to store other radio stations.
To exit manual preset mode
G Press Ç on the system.
Notes:
– If you attempt to store more than 40 preset
radio stations, "FULL" is displayed.
– During programming, if no key is pressed within
20 seconds, the system will exit the programme
mode automatically.

Tuning to preset radio stations

G Once you've programmed the radio stations,
press í or ë to select the desired preset
number.
➜ The preset number, radio frequency, and
waveband are displayed.
Radio Reception

Erasing a preset radio station

1
Press í or ë to select the preset radio station
to be erased.
2
Press and hold Çon the system until
"PRESET DELETED" is displayed.
➜ The deleted radio frequency remains on the
display.
➜ The preset numbers of all other preset radio
stations in the band with higher numbers are
also decreased by one.
G Repeat steps 1–2 to erase other preset radio
stations.

Changing tuning grid

all versions)
In North and South America, the frequency step
between adjacent channels in the MW band is
10 kHz (9 kHz in some areas). The preset
frequency step in the factory is 9 kHz.
Changing the tuning grid will erase all
previously stored preset radio stations.
1
Disconnect the system from the AC power
supply (pull out the AC power cord).
2
While holding down TUNER and á on the
system, reconnect the system to the AC power
supply.
➜ The display will show "GRID 9" or
"GRID 10".
Notes:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
– The FM tuning grid also will be changed from
50 kHz to 100 kHz or vice versa.
For Recording, please refer to "Tape
Operation/Recording".
(not available for
25