Step 3: Connecting Tv Set; Using Video In Jack (Cvbs); Using Component Video In Jack (Pr Pb Y) - Philips FW-D596 User Manual

Step 3: Connecting TV set

IMPORTANT!
– You only need to make one video
connection from the following options,
according to the capabilities of your TV
system.
– S-Video or Component Video
connection provides higher picture
quality. These options must be available
on your TV set.
– Connect the system directly to the TV
set.

Using Video In jack (CVBS)

● Use the composite video cable (yellow) to
connect the system's CVBS jack to the video
input jack (or labeled as A/V In, Video In,
Composite or Baseband) on the TV set.
● To listen to TV channels through this system, use
the audio cables (white/red) to connect AUX/
TV IN (L/R) jacks to the corresponding
AUDIO OUT jacks on the TV set.
Television
Y
LINE
OUT
AUX/
TV
IN
IMPORTANT!
– If both S-Video and Component (Pr
Pb Y) Video connections are used to
connect to your TV set, the Video signal
will automatically switch to S-Video
when you power up the system. To set
the VIDEO OUT (put) to 'Pr Pb Y', see
page 31, Using the Setup Menu – Setting
the video out.

Using component Video In jack (Pr Pb Y)

● Use the component video cables (red/blue/
green) to connect the system's Pr Pb Y jacks to
the corresponding Component video input jacks
(or labeled as Pr/Cr Pb/Cb Y or YUV) on the TV
set.
● To listen to TV channels through this system, use
the audio cables (white/red) to connect AUX/
TV IN (L/R) jacks to the corresponding
AUDIO OUT jacks on the TV set.
Connections
P D D
( (
D U U U
(CVBS)
11