Advertisement
C-8515
POWER RACK SYSTEM
DRAWING #2
REAR
FRONT PLATE
FRONT UPPER CROSS BEAM
PLATE
CHIN BARS
REAR UPPER
CROSS BEAM
THIS UNIT IS BULKY AND VERY HEAVY. TWO PEOPLE ARE REQUIRED TO ASSEMBLE THIS UNIT.
THIS UNIT REQUIRES (2) 3/4 WRENCHES FOR ASSEMBLY. DO NOT TIGHTEN HARDWARE UNTIL INSTRUCTED
TO.
1) PUSH (2) FEET ONTO (2) BASES. PUSH (2) FEET ONTO REAR CROSSBEAM. ATTACH (4) UPRIGHTS TO (2)
BASES WITH (12) ½ X 3 ½ BOLTS, (24) ½ FLAT WASHERS, AND (12) ½ LOCK NUTS.
2) PUSH (2) SAFETY BARS THROUGH UPRIGHTS. ATTACH REAR LOWER CROSS BEAM TO (2) BASES WITH (4)
½ X 3 ½ BOLTS, (8) ½ FLAT WASHERS, AND (4) ½ LOCK NUTS.
3) ATTACH (1) UPPER REAR CROSS BEAM, (2) UPPER SIDE CROSS BEAMS, AND (1) UPPER FRONT CROSS
BEAM TO THE TOP OF (4) UPRIGHTS WITH (4) CORNER PLATES, (16) ½ X 3 ½ BOLTS, (32) ½ FLAT WASHERS,
AND (16) ½ LOCK NUTS.
4) USE LEVELING SCREWS TO LEVEL BASE. ATTACH (2) CHIN BARS TO UPPER FRONT CROSS BEAM WITH (4)
½ X 3 ½ BOLTS, (8) ½ FLAT WASHERS, AND (4) ½ LOCK NUTS. SET UNIT ON LEVEL SURFACE AND TIGHTEN
HARDWARE.
5) INSTALL J HOOKS, SAFETY BARS, WEIGHT PINS, AND DIP BARS.
HARDWARE LIST
(36) ½ X 3 ½ BOLT
(72) ½ FLAT WASHER
(36) ½ LOCK NUT
(4) 2 ½ FOOT
(4) 2 ½ PLUG
NOTE: ALL MEASUREMENTS ARE IN INCHES.
Advertisement
