Cd Player - Philips AZ 1025 Owner's Manual

DIGITAL TUNER
PROGRAMMING RADIO STATIONS
1. Tune to your desired station, following steps 1-3 under 'Tuning
to radio stations'.
™ If the frequency is already stored in the memory, the preset
number will be displayed.
2. Press PROG to activate programming.
™
flashes in the display.
PROGRAM
3. Press the PRESET control (up or down) to allocate a preset
station number from 1 to 29.
4. Press PROG again to confirm the setting.
5. Repeat steps 1-4 to store all other presets.
• You can clear a preset number by storing another frequency in
its place.
To deactivate programming mode
If during programming you decide not to program a station, adjust
the CD TUNER TAPE/
OFF
Tuning to preset stations
Press the PRESET 4, 3 control (down, up) until the desired
number is shown.
DISPLAY INDICATION FOR CD FUNCTIONS
: when the CD door is opened.
- Total track number and playing time: in stop mode.
: when no disc is inserted.
: error in CD operation or with the CD
(see 'Troubleshooting').
– Current track number and elapsed playing time:
during CD playback.
– Elapsed playing time freezes and flashes:
in PAUSE position.
– / (
SHUFFLE REPEAT ALL
activated.
: program mode is active.
PROGRAM
: appears briefly and the selected track number (1-20) when
PROG
you program.
FULL: program memory full.
:
– when you cancel a CD program; you press PROG for more
than two seconds but no track has been selected.
:
– you press PROG but no track has been selected.
slider to CD or TAPE/
OFF
) modes: when the respective mode is
position.

CD PLAYER

TUNER TUNER
CD
PROGRAM
TUNER
TUNER
CD
TUNER
TUNER
CD
TUNER
CD
PROGRAM
AM
11