Cisco Aironet 1530 Getting Started Manual page 15

The FCC limits the amount of power this device can transmit. Power transmitted is a
Note
combination of the amplification of the signal and the antenna gain. The access point has been
designed to operate with the Cisco provided antennas.
Power
For detailed information on the power options available for the 1530 series access points, see
Note
the Cisco Aironet 1530 Series Outdoor Access Point Hardware Installation Guide.
Warning Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning This equipment must be externally grounded using a customer-supplied ground wire
before power is applied. Contact the appropriate electrical inspection authority or an
electrician if you are uncertain that suitable grounding is available. Statement 366
Warning Do not work on the system or connect or disconnect cables during periods of lightning
activity. Statement 1001
The 1532E access point supports these power sources:
• DC power—24- 57 VDC
• Power-over-Ethernet (PoE)
Do not place the power injector in an unprotected outdoor environment because water
Caution
could get into the power injector and cause a short circuit and possible fire.
Warning Connect the unit only to DC power source that complies with the Safety Extra-Low
Voltage (SELV) requirements in IEC 60950 based safety standards Statement 1033
15