Siemens MICROMASTER 420 Reference Manual page 54

‡u
Bits 15 - 0
•
If a parameter value is requested by the master, the values in PWE1 and
PWE2 of the master telegram to the inverter are ignored.
•
The meaning of the 3
whether variable or fixed length PKW has been selected using P2013.
The examples should explain this more clearly later in this section.
•
The MICROMASTER 420 parameter list must be consulted to understand
the meaning of the parameter values, and their appropriate settings.
46
WK
nd
= 2 Parameter value for array parameters and task
for all elements.
= Low word of parameter value (no array).
th
= Low word of n parameter value for array
th
parameter and task for n element.
st
= Low word of 1 parameter value for array parameter
and task for all elements.
= Next accessible ID.
= Next or previous valid value (16 bit).
= High word of the next or previous valid value (32
bit).
In the right order: Å
If new value > actual value Å
If new value < actual value
rd
and 4
QG
When value of P2013
= 4 (fixed) or
= 127 (variable length)
and single word parameter.
When value of P2013
= 4 (fixed) or
= 127 (variable length)
and double word parameter.
When value of P2013.
= 127 (variable length)
and 32 bits parameter.
Slave
Task cannot be executed.
Error value = ID not exist or ID
not accessible.
When value of P2013
= 127 (variable length).
Slave
Task cannot be executed.
Error value = Value no
admissible or New max. /min.
next valid value. value exist.
previous valid value. When value of P2013
= 127 (variable length).
th
words, PWE1 and PWE2 is dependent on
MICROMASTER 420 Reference Manual
Å
Master and replay ID =
Å
Master and replay ID =
Issue A1