Time-Setting Options; Kitchen Timer; Stopwatch; Automatic Safety Cut-Out - Bosch ET375FAB1E Instruction Manual

OTime-setting options
There are 2 different time-setting options:
i o n s T i m e - s e t t i n g o p t

Kitchen timer

■

Stopwatch

■
Kitchen timer
You can use the kitchen timer to set a time of up to
99 minutes. It runs independently of all the other
settings.
Setting the kitchen timer
If the appliance is switched off, touch the
1.
once; if it is switched on, touch the
The indicator lights up.
V
display.
When the appliance is switched on, pressing
Note:
the symbol once switches on the stopwatch.
0
Set the desired time in the settings range.
2.
The timer starts counting down after a few seconds.
When the time has elapsed
When the time has elapsed, an audible signal sounds
and flashes on the display for 10 seconds. The
‹‹
indicator flashes.
V
Touch any symbol.
The indicators go out and the audible signal ceases.
Setting the correct time
Use the symbol to select the kitchen timer and reset
0
the time.
Stopwatch
The stopwatch displays the time that has passed since
it was activated.
The stopwatch only works when the appliance is
switched on. When the appliance is switched off, the
stopwatch is switched off as well.
If the kitchen timer is selected in addition to the
Note:
stopwatch, the setting will appear on the timer display
for 10 seconds. The temperature will then be displayed
again.

Switching on

Touch the symbol.
0
1.
is shown on the display.
‹‹
Touch the control panel.
2.
Timing starts. Seconds are displayed during the first
minute, then minutes. After 10 seconds the timer
display goes out and the temperature is shown.
Touch the symbol to show the timer display
0
3.
again.

Switching off

Touch the 0 symbol.
1.
The timer display will be shown.
Touch the control panel.
2.
The stopwatch will be switched off. The timer display
will go out.
symbol
0
symbol twice.
0
min lights up on the
‹‹
bAutomatic safety cut-out
If an appliance remains switched on for a long time
c u t - o u t A u t o m a t i c s a f e t y
without any settings being changed, automatic switch-
off is activated.
Heating of the appliance is stopped.
alternately in the display.
The indicator goes out when you touch any control. You
can implement new settings.
When the time limit is activated depends on the
temperature selected (2 to 4 hours).
kWipe protection
If you wipe over the control panel while the appliance is
W i p e p r o t e c t i o n
switched on, settings may be altered.
To prevent this from happening, your appliance has a
wipe protection function.
Switching on
Touch the symbol when the appliance is switched on.
„
An audible signal sounds. The
The control panel is locked for 30 seconds. You can
now wipe over the control panel without altering any
settings.
The main switch is excluded from the wipe
Note:
protection function. You can switch off the appliance at
any time.
Switching off
Touch the „ symbol.
The wipe protection function is switched off.
[Energy consumption
indicator
You can use this function to display the total energy
n i n d i c a t o r E n e r g y c o n s u m p t i o
consumption between switching the appliance on and
off.
Once switched off, the energy consumption in kilowatt
hours (e.g. 1.87 kWh) is displayed for 10 seconds.
The accuracy of the display depends, amongst other
things, on the voltage quality of the power supply.
The energy consumption display may not be
activated.~ "Basic settings" on page 12

Time-setting options

" ‰ and • / œ flash
indicator lights up.
Ñ
en
11