Trouble Shooting; E-Report In The Displays - Bosch ET375FAB1E Instruction Manual

Trouble shooting

en
3Trouble shooting
:
Warning – Risk of electric shock!
T r o u b l e s h o o t i n g
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers. If
the appliance is faulty, unplug the mains plug or switch
off the fuse in the fuse box. Contact the after-sales
service.
Faults often have simple explanations. Please read the
information in the table before calling the after-sales
service.
The electronics of your appliance are underneath the
control panel. For various reasons, the temperature in
this area may rise sharply.
The appliance can be set to switch off automatically in
order to prevent the electronics from overheating.
and or appear alternately in the display.
• œ
Display Error
None The power supply has been disconnected.
All displays flash The touch controls are wet or an object is rest-
ing on them.
Appliance fault
"‹
The electronics have overheated. The appli-
"...
ance has therefore been switched off.
Safety cut-out
"‡
Appliance fault
"ˆ
The appliance was in operation for too long and
"‰
has switched itself off.
Demo mode is switched on
š" Appliance does not
heat up

E-report in the displays

When an error message with "E" appears in the display,
e.g. E0111, switch the appliance off and on again.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.
14
"...
Remedy
Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
Dry the controls or remove the object.
Switch off the appliance and switch it back on again. If the display appears
again, call the after-sales service.
Wait until the electronics have cooled down sufficiently. Touch any control.
"... goes out.
Switch off the appliance and allow it to cool down. Fill the frying basin with
frying oil/fat up to the top marking. Push the safety pin on the front of the
housing in firmly.
Switch off the appliance and switch it back on again. If the display appears
again, call the after-sales service.
Switch the appliance on again.
Switching off demo mode: Disconnect the appliance from the power sup-
ply for 30 seconds (switch off the household fuse or the circuit breaker in
the fuse box). Switch on the appliance. Touch any control in the next
3 minutes. Demo mode is switched off.