Clock; Clock Setting - Philips C50 Owner's Manual

RECORDING
21
• Recording will start automatically.
5 Press STOP•OPEN on tape deck 1
and tape deck 2 to stop dubbing.
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 2 to tape deck 1.
– To ensure good dubbing, use tapes of
the same length.
Recording from other
sources
(only on tape deck 1)
1 Load a blank tape into tape deck 1.
2 Press CD, TUNER or AUX.
• Start playback of the selected source.
3 Press RECORD on tape deck 1 to
start recording.
™ The starts flashing.
REC
4 Press PAUSE to interrupt
recording.
5 Press STOP•OPEN on tape deck 1
to stop recording.
Note:
– During recording, it is not possible to
listen to another sound source.
pg 01-28/C50-C70/37-Eng 21

CLOCK

MINI HIFI SYSTEM
PROGRAM SHUFFLE
REPEAT TIMER REC
NEWS T.A. AM MW FM LW
60Hz 250Hz 500Hz 1KHz
STANDBY
ON
CLOCK/
TIMER CD 1 • 2 • 3 FM • AM
CD TUNER
PROG
SEARCH • TUNING
STOP • CLEAR PLAY PAUSE
UP
SOUND NAVIGATION
SOUND
DIGITAL SOUND
DOWN
CONTROL
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER,
etc.). The clock will be displayed for
about seven seconds.
• Press CLOCK/TIMER briefly.
™ "PM 10:38 or 22:38 " (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
™ "--: : : : : --" will be displayed if the
clock is not set.
Note:
– When the system goes into low power
standby mode, the clock setting will not
be displayed (for model FW-C70 only).
18/11/1999, 2:39 PM
C
STEREO
BACK
FRONT HSD
L R
2KHz 4KHz 8KHz
PRO LOGIC
DOLBY B
S S
NR
RDS
NEWS!
TAPE 1 • 2 VIDEO
TAPE AUX
PRESET
PREV NEXT
VOLUME
DYNAMIC BASS
BOOST

Clock Setting

The clock can be set in either 12- or
24-hour mode, e.g. "AM 12:00" or
"00:00". Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK/TIMER to select
clock mode.
2 Press PROG (on the system only) to
select 12- and 24- hour mode.
™ If 12-hour mode is selected, "AM
12:00" starts flashing.
™ If 24-hour mode is selected,
"00:00" starts flashing.
3 Set the hour with à or á on the
system.
4 Set the minute with í or ë on the
system.
5 Press CLOCK/TIMER again to
store the setting.
™ The clock starts.
3139 116 19441 (ENG)