Service And Maintenance - Craftsman 247.299321 Operator's Manual

Before performing any type of maintenance/service, disengage all controls
and stop the engine. Wait until all moving parts have come to a complete
stop. Disconnect spark plug wire and ground it against the engine to prevent
unintended starting. Always wear safety glasses during operation or while
performing any adjustments or repairs.
Interval Item
Each Use 1.
2.
3.
4.
1st 2 hours 1.
2.
1st 5 hours 1.
Every 10 hours 1.
2.
Every 25 hours 1.
Every 30 hours 1.
2.
Every 50 hours 1.
Every 100 hours 1.
2.
Before Storage 1.
† — Change oil every twenty five hours when operating engine under heavy load or in high temperatures.
Always stop engine and disconnect spark plug wire before performing any
maintenance or adjustments. Always wear safety glasses during operation
or while performing any adjustments or repairs.
General Recommendations
• Always observe all safety rules found on product labels and in this operator's
manual when performing any maintenance. Safety rules can be found on the
product labels and in this Operator's Manual beginning on page 3.
• The warranty on this tiller does not cover items that have been subjected to
operator abuse or negligence. To receive full value from warranty, operator
must maintain the equipment as
instructed here.
• Some adjustments will have to be made periodically to maintain your unit
properly.
• Periodically check all fasteners and make sure these are tight.

SERVICE AND MAINTENANCE

MAINTENANCE SCHEDULE
WARNING
Engine oil level
Loose or missing hardware
Engine and around muffler
Air cleaner
Drive belt tension
Nuts and Bolts
Engine oil
Drive belt tension
Unit
Spark plug
Tines for wear
Tire pressure
Engine oil†
Air cleaner
Spark Plug
Fuel system
WARNING
Follow the maintenance schedule given below. This chart describes service guidelines
only. Use the Service Log column to keep track of completed maintenance tasks. To
schedule service from Sears Parts & Repair, call 1-888-331-4569.
Service
1. Check
2. Tighten or replace
3. Clean
4. Check
1. Check
2. Check
1. Change
1. Check
2. Lubricate
1. Check
1. Check
2. Check
1. Change
1. Change
2. Change
1. Run engine until it stops from lack of fuel
or add a gasoline additive to the gas in
the tank.
Engine Maintenance
If the engine has been running, the muffler will be very hot. Be careful not
to touch the muffler.
Checking the Spark Plug
DO NOT check for spark with spark plug removed. DO NOT crank engine
with spark plug removed.
To ensure proper engine operation, the spark plug must be properly gapped and
free of deposits. Check the spark plug every 25 hours and replace it every 100 hours.
16
Service Log
WARNING
WARNING