Avaya 8600 Technical Configuration Manual page 11

config vlan 3 ports remove 1/1-1/48,2/1-
2/8 member portmember
config vlan 3 ports add 1/48 member
portmember
config vlan 3 ports add 1/48 member static
config vlan 3 ip create 10.1.30.2/24
config vlan 3 ip rip enable
config vlan 3 ip rip supply disable
config vlan 3 ip rip listen disable
4 Configuration of Brouter port #1
config ethernet 2/7 ip create 10.1.1.1/30
2090
config ethernet 2/7 ip rip enable
5 Enable RIP Globally
config ip rip enable
ERS8600 Configuration File:
# PORT CONFIGURATION - PHASE I
#
ethernet 1/48 perform-tagging enable
# VLAN CONFIGURATION
#
vlan 1 ip igmp mrdisc mrdisc-enable disable
vlan 2 create byipsubnet 1 10.1.20.0/255.255.255.0
vlan 2 ports remove 1/1-1/47,2/1-2/8,3/1-3/8 member portmember
vlan 2 ports add 1/48 member portmember
vlan 2 ports add 1/48 member static
vlan 2 ports remove 1/1-1/47,2/1-2/8,3/1-3/8 member portmember
vlan 2 ip create 10.1.20.2/255.255.255.0 mac_offset 0
vlan 2 ip rip enable
vlan 2 ip rip listen disable
vlan 2 ip rip supply disable
vlan 3 create byipsubnet 1 10.1.30.0/255.255.255.0
November 2010
ERS 8600 / ERS 8800 RIP Technical Configuration Guide
These commands configure port 1/48 as a static member
for VLAN 2 and remove all other potential members.
This command adds the IP address of 10.1.20.2/24 to IP
Subnet VLAN 3
This command enables RIP for VLAN 3 and disables RIP
supply and listen.
This command adds the IP address of 10.1.1.1/30 to port
2/7using brouter VLAN = 2090.
This command enables RIP on this interface.
avaya.com
11