Charging; Charging The Headphones; On/Off Control; Power On - MAXTEK 76747 User Manual

Charging

Charging The Headphones

Plug the micro USB cable into the charge port and the other end into
a USB port no greater than 1 amp. It takes approximately 3 hours to
fully charge the headphones. The LED will show red when the
headphones are on charge. When the battery is full, the red LED will
turn white. Only charge the headphones when they are turned off.
Please note:
When using the headphones for first time, please ensure the battery has been fully
charged before use.
CHECK the mains adaptor output BEFORE charging - 5V/1A Maximum.

On/Off Control

Power On

Press and hold the function button for approximately 3 seconds until
a red LED indicator is flashing. You will also hear "Power on".

Power Off

Press and hold the function button for approximately 3 seconds until
you see the red LED go out. You will also hear "Power off".

Standby Mode

If the unit is left inactive for a few minutes it will revert to standby
mode. Press the function button to wake the headphones.
6
After Sales Support
UK/N.IRELAND HELPLINE N
REP.IRELAND HELPLINE N
O
WEBSITE:
EMAIL: enquiries@quesh.co.uk
: 01270 508538
O
: 1800 995 036
www.quesh.co.uk