7. PC Setup via Operator Software OS3.x
You can apply the full set of functions when you use a PC and our operator software OS3.x for
setup of the unit (at this time the actual version is OS3.2).
You can download this software and full instructions, free of charge, from our homepage
Connect your PC to the converter, using a serial RS232 cable like shown in section
4.5
of this
manual. Make sure, the cable only uses pins 2, 3 and 5. Pins 2 and 3 must be crossed.
Run the OS3.x software and you will see the following screen:
In case your text and color fields remain empty and the headline says „OFFLINE", you must
verify your DIL switch setting and the serial settings of the unit. To access serial settings,
please select „COMMS" from the menu bar.
Fu252_02g_oi_e.doc / Apr-16
Page 18 / 36
www.hohner-elektrotechnik.de
18