Infinition Labradar User Manual page 2

Important Safety Instructions
!
1. Carefully read all of the instructions provided and save them for later use. Read all warnings and
instructions marked on the LabRadar.
2. Do not place the LabRadar on an unstable stand or surface as it may fall resulting in serious
damage.
3. The LabRadar must be operated either by 6 AA batteries or by plugging the USB cord to a
computer's USB port.
4. Do not allow any objects to rest on the USB cord or place the LabRadar where the USB cord will be
trampled on.
5. Do NOT plug in, turn on or attempt to operate an obviously damaged unit.
6. No operator serviceable parts inside the LabRadar radar unit. Please refer servicing to service
qualified personnel.
Notes:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

Consult the dealer or an experienced radio/TV technician for help.
This devices complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received, including interference that may cause undesired
operation of the device.
Cet appareil est conforme à Industrie Canada une licence standard RSS exonérés (s). Son fonctionnement est
soumis aux deux conditions suivantes:
1. Cet appareil ne doit pas provoquer d'interférences
2. Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant provoquer un
fonctionnement indésirable de l'appareil.
Infinition Inc. Rev. 02 2