JVC RX-F10S Service Manual page 9

www.freeservicemanuals.info
3.7 Removing the primary board
(See Fig.10)
• Remove the top cover and video/audio I/O board.
(1) From the top side of the main body, remove the divider.
(2) Disconnect the wire from the connector
ondary board.
(3) Disconnect the wire and power cord from the connectors
(CN202, CN203) on the primary board.
(4) Remove the four screws K and screw K' attaching the pri-
mary board.
Reference:
When attaching the screw K', attach the barrier with it.
(5) Take out the primary board from the main body.
3.8 Removing the power transformer
(See Fig.11)
• Remove the top cover.
(1) From the top side of the main body, remove the tie bands
and wire clamp bundling the wires.
Reference:
After reassembling, bundle the wires with the new tie
bands and wire clamp as before.
(2) Disconnect the wire from the connector
ondary board.
(3) Disconnect the wire from the connector
mary board.
(4) Disconnect the wire from the connector
amplifier board.
(5) Remove the four screws L attaching the power transform-
er.
(6) Take out the power transformer from the main body.
CN208 on the sec-
CN202
Wire
CN203
Power transformer
CN201 on the sec-
CN202 on the pri-
CN702 on the main
L
Wire
Published in Heiloo, Holland.
K
Divider
Primary board
CN208
K' K
Wire
Barrier
Power cord
Fig.10
Wire clamp
L
Wires
CN201
L
CN202
Wire
Primary board
Fig.11
4/22/16
Secondary board
Main amplifier board
Tie bands
CN702
Secondary board
(No.MB206)1-9