JVC RX-F10S Service Manual page 10

www.freeservicemanuals.info
3.9 Removing the secondary board
(See Fig.12)
• Remove the top cover.
(1) From the top side of the main body, remove the divider.
Reference:
When reassembly, attach the divider as before.
(2) Remove the tie bands bundling the wires.
Reference:
After reassembling, bundle the wires with the new tie
bands as before.
(3) Disconnect the wires from the connectors (CN201, CN207,
CN208, CN211, CN216, CN261, CN412, CN510, CN520,
CN721) on the secondary board.
Reference:
Disconnect the wire from the connector
main amplifier board as required.
(4) Remove the three screws M and screw M' attaching the
secondary board.
Reference:
When attaching the screw M', attach the earth wire with
it.
(5) Take out the secondary board from the main body.
Reference:
When attaching the secondary board, insert the section
e of the secondary board in the hole of the heat sink and
attach the secondary board.
1-10 (No.MB206)
Divider
Wires
M
CN702 on the
Wire
CN201
Secondary board
Published in Heiloo, Holland.
Main amplifier board
Heat sink
CN412
CN211
CN216
e
Tie bands
M
CN261
CN721
Wire
CN520
CN208
Fig.12
4/22/16
CN207
M'
CN702
M
CN510
Earth wire