Advertisement
Basic LCD Alert Messages
LCD Messages
Description
Online Comm Err
Communications error (primarily
related to serial communications
with the host).
No floppy diskette detected in
Floppy Failed
disk drive.
No Fonts Found
Font files unreadable, missing, or
corrupted.
No App Found
Application flash unreadable or
corrupted.
No Setup Found
Setup files unreadable, missing,
or corrupted.
These are scrolling messages;
wait for the entire message for
complete instructions.
Bin A Empty
Out of stock in Stock A
Load Stock
Alternating Message
Out of stock in Stock B
Bin B Empty
Alternating message.
Load Stock
Jam Burster
Burster failure
Clear – Reset
Alternating message.
Document jam at exit
Jam Exit
Alternating message.
Clear – Reset
Jam Bin A
Document jam at Bin A
Clear – Reset
Alternating message.
Document jam at Bin B
Jam Bin B
Clear – Reset
Alternating message.
Jam Encoder
Document jam at Encoder
Clear – Reset
Alternating message.
1
Indicates that the two messages are alternately displayed while the alert exits
Galileo by Travelport obtained written permission from Unimark to reproduce contents of the Sprite Quick Reference Card 71U-1405-500; REV B, © 2006 Unimark Products, LLC. for
the ADP 4000 Quick Reference Card. No part of this publication may be reproduced or transmitted without prior written permission of Galileo by Travelport, or Unimark, Inc.
ADP 4000 Quick Reference Card
Corrective Action (ALERT CLEAR)
Typical message sequence when the Unit detects that the incoming data does not match its
communication parameters such as baud rate, parity, or data/stop bit size.
Insert Unimark Application System Software floppy diskette in disk drive. Ensure diskette is fully
inserted in disk drive.
Insert backup floppy diskette in disk drive.
Ensure diskette is fully inserted in disk drive.
Controller board is most likely unusable.
Contact Unimark Service.
Insert backup floppy diskette in disk drive.
Ensure diskette is fully inserted in disk drive.
Setup files could be replaced on floppy, or unit may automatically recreate them if possible.
1
.
Replenish Stock A supply. Soft alert cleared.
1
Replenish Stock B supply. Soft alert cleared.
1
.
Remove damaged stock from burster area and press RESET/EXIT push-button to clear hard alert.
1
Clear jam, load stock correctly, and press RESET/EXIT push-button to clear hard alert
1
.
Clear jam, load stock correctly, and press RESET/EXIT push-button to clear hard alert.
1
.
Clear jam, load stock correctly, and press RESET/EXIT push-button to clear hard alert.
1
.
Clear jam, load stock correctly, and press RESET/EXIT push-button to clear hard alert.
ADP 4000 Printer Quick Reference Guide (January 2007)
.
7
Advertisement
