Table of Contents
Advertisement
3.7
Removing transportation securing plates
The magnetic gasket seal on the door is protected from
mechanical damage by means of the securing plates (M).
Prior to adjusting the door and/or activation of the
coldroom, these must be removed.
3.8
Adjusting the hinges
Important!
lf the magnetic gasket profile does not fit properly
around the whole periphery of the door and the sealing
profile does not lie flush on the threshold or the flooring
on the inside, deviations can be adjusted for in three
ways on the door hinges.
Remove covering caps (N) from the door hinges. Open the
door and insert a nail, a small screwdriver or something (M)
similar diagonally into the opening (K) with the cap in order
to release the cap locking.
After releasing the screw (P) or (R), the door can be adjusted
horizontally or depthwise.
For vertical adjustment, turn the screws of the rising hinges
(T) so that the door reaches the wanted height (see image).
The non-rising hinge can be mounted on the left or on the
right side. It has the same screw (T) at the top and at the
bottom. For vertical adjustment, turn the screw (T) so that
the door is in the wanted height. For that, first release the
upper screw (T) and then adjust the hinge turning the lower
screw (T). Finally, fasten the upper screw (T) so that the
hinge can still be moved easily.
3.9
Door lock fastener
The door lock fastener (V) of the hairpin lock has been
factory-fitted at the plant. After assembly and adjustment
of the door, the fit of the lock behind the door lock fastener
should be tested.
lf adjustment is necessary, loosen screws (U), and insert
support (W) if necessary, adjust door lock fastener and
tighten screws again.
Check that see if the door has a tight seal. After that, drill
holes with a 3.7 mm drill and fix the fastener additionally
with the screws provided (X).
General notice (liability): the details of this technical documents serve for description. Consents regarding the availability of certain features or
regarding a certain purpose always require a special written agreement.
Page 9 GB
M
P U
N
P
R
T
R
N
W
Right reserved to make technical changes!
GB
M
K
K
M
V
U
X
Advertisement
Table of Contents
