Table of Contents
Advertisement
6. Commissioning
6.1
Commissioning the coldroom
- only for the intended or agreed purpse
After assembly, clean and ventilate the coldroom.
(See section „Cleaning the Coldroom").
The coldroom is ready to operate. The refrigeration unit can
be activated according to the separate Operating Manual.
Allow the temperature in the coldroom to reach the
desired value. Place refrigerated goods in the coldroom
only when this value has been reached.
Have the pressure compensation valve checked by a refri
geration specialist. Do not exceed the allowed pressure
differential in the coldroom of 100 Pa (1 mbar). Check the
function of the pressure compensation valve regularly. The
opening of the valve must not be blocked internally or
externally (e.g. by refrigerated goods).
6.2
Permissible loads for flooring panels
Wheel load N
Wheel load N
> 1 cm
2
> 4 cm
hard
rubber wheel
bakery wheel
1.
250
6.3
Deactivation
When the coldroom is to be deactivated for a long period,
the power supply plug must be disconnected or the power
supply must be switched off. Provide sufficient ventilation!
6.4
Cleaning the coldroom
During cleaning the refrigeration unit and the coldroom
should be cut off from the power supply.
Remove the plug from the power supply during such
work and secure against the plug being reinserted, or
switch off the power supply at source and secure
against switching on.
General notice (liability): the details of this technical documents serve for description. Consents regarding the availability of certain features or
regarding a certain purpose always require a special written agreement.
Page 13 GB
Wheel load
2
in N/m
2
1000
30.000
Elements with powder-coated steel plate surfaces or
stainless steel surfaces: do not spray water onto walls,
ceilings, elements with electrical components (e.g. door
frame) or the refrigeration units inside or outside. Wipe out
the inside of the coldroom, dry well and allow ventilation.
Do not use scouring agents or cleaning agents containing
solvents. Wipe the outside of the coldroom with a damp
cloth.
Standard floor:
Only wipe with a moist cloth Not suited for stagnant
water or jet water!
Wash the door seals regularly with soapy water and wipe
dry. Do not clean the seals with Aceton or
solventcontaining detergent.
The walls, shelves, containers and packing materials
can be washed off with potassium sorbate solution
(1 tablespoon of potassium sorbate dissolved in
0.1 litre of water. Potassium sorbate is produced by
Merck and available at the local chemist's.) Wipe the
walls, shelves, etc., with a linen towel dampened by
the solution. The solution should dry onto the parts
cleaned, leaving a light coat of residue.
The stainless steel coldroom flooring can be treated
with normal stainless steel cleaners (e.g. ETOLIT, Fa.
Viessmann). Seal the stainless steel surface with an
appropriate material for stainless steel (e.g. Chromadur,
Fa. Assindia-Chemie or Inox Top, Fa. Viessmann).
Pay attention to the product information!
GB
Right reserved to make technical changes!
Advertisement
Table of Contents
