Table of Contents
Advertisement
GB
1.5
Assembly of the coldroom
Install the coldroom in a well ventilated room to ensure
that the heat produced by the refrigeration unit is properly
released and the room is not excessively heated. This will
reduce the running time of the refrigeration unit, thus
reducing running costs and the wear on the refrigeration
unit. The distance of the coldroom to the wall, and the
space above the coldroom should be a minimum of 50 mm
for coldrooms in above zero applications. For coldrooms in
below zero applications the space should be at least 100
mm. Please see the assembly instructions for the required
clearance above the cell for a refrigeration unit. The
assembly height has to be arise according to the
potential prop construction. Before starting to install the
device, check the dimensions of the intended place of
installation. With this, also the right angularity has to be
checked by diagonal measurement.
lt should be ensured that the flooring panels are only
installed on even and smooth floors (according German
VOB regulations). In case of uneven floors (e.g. cement) the
difference must be compensated for using flooring inserts.
Coldrooms and deep freezers operated below -5°C must be
placed on flooring plates as protection against freezing. An
electrical floor heating can be used instead of floor plating.
Installation outdoor
The Viessmann coldrooms are suitable for installation
outdoor - but this must be done under a protective roof.
(local construction measures)
lf coldrooms are installed outdoor, discolouring of the paint
may occur as a result of UV radiation.
In addition to these assembly instructions, the
applicable national and local rules on work safety must
be observed when carrying out assembly work and the
proper measures to prevent accidents must be taken!
General notice (liability): the details of this technical documents serve for description. Consents regarding the availability of certain features or
regarding a certain purpose always require a special written agreement.
Page 4 GB
1.6
Disposing of the coldroom
Any waste materials must be disposed of in
accordance with the local and international laws.
Right reserved to make technical changes!
Advertisement
Table of Contents
