Philips 240S4LPMS/00 Service Manual page 84

Meridian 3
84
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
< = 20 gloss units
Tilt and swivel base
Tilt angle
Swivel angle :
High Adjustment : nil
Portrait Display :
Kensington Lock
Must meet Kensington_slot.spec "TYE-M0004".
MMD request metal plate in Kensington hole.
Label
Regulatory label / Carton label should follow Philips requirement.
China RoHS label
Detail document refer to Philips Engineering Reference Book.
Product dimension / Weight ( Refer to Philips approved SHT 191/SHT560 )
Unit dimension :
Packed unit dimension:
Net weight
Gross weight
Transportation
Transportation standards refer to UAN-D1534/00/01/02.
Transportation packages
Net weight Packaging and wrapping shall be sufficient to protect the product against damage
or loss during shipment from the supplier to the destination specified in the purchase order.
All packaging materials are subject to test and evaluation per UAN-D1534/00/01/02.
The cushion material shall be constructed using EPS material.
The doggy hole is requested.
Transportation Test
Overall tests refer to UAN-D1534/00/01/02.
Vibration, drop test should be performed at ambient temperature (20°C to 23
humidity (40% to 65%).
: -5 +2/- 0 (forward)
+20 + 0/- 3 (backward)
nil
nil
:
o
C) and relative