Accessories; System Configuration; Operation To Reset; Table Of Contents - Kenwood RXD-NV500 Service Manual

RXD-NV500/NV600
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS............. 2
CONTROLS ................................................................3
DISASSEMBLY FOR REPAIR....................................4
BLOCK DIAGRAM ......................................................5
CIRCUIT DESCRIPTION ............................................6
ADJUSTMENT ..........................................................11

Accessories

FM indoor antenna (1)
(T90-0836-05)
Batteries (R6/AA) (6)

System configuration

SYSTEM RECEIVER
NV-500 RXD-NV500
NV-600 RXD-NV600
Cautions

Operation to reset

The microcomputer may fall into malfunction (impos-
sibility to operate, erroneous display, etc.) when the
power cord is unplugged while unit is ON or due to
an external factor. In this case, execute the following
procedure to reset the microcomputer and return it
to normal condition.
÷ Please note that resetting the microcomputer clears the
contents stored in and it returns to condition when it left
the factory.
Unplug the power cord from the power outlet then,
while holding the CD Open close ( 0 ) key de-
pressed, plug the power cord again.
After some time, the power will be switched off and
return will be made to the initial status.
2 2
Loop antenna (1)
(T90-0837-05)
Remote control unit (1)**
(A70-)
SPEAKER
LS-NV500
LS-NV600S
WIRING DIAGRAM ...................................................12
PC BOARD .............................................................. 13
SCHEMATIC DIAGRAM .......................................... 19
EXPLODED VIEW ....................................................33
PARTS LIST..............................................................35
SPECIFICATIONS ....................................................44
*AC plug adaptor (1)
(E03-0115-05)
* Use to adapt the plug on the power
cord to the shape of the wall outlet.
(Accessory only for regions where
use is necessary.)
** Refer to part list.
Note related to transportation and movement
Before transporting or moving this unit, carry out the
following operations.
1 Select the CD input
2 Press the 0 key and take out the CD.
3 Ensure that "No Disc" is displayed.
4 Wait for a few seconds, then set the power
OFF.
CD TUNER
6
/BAND
0