Disassembly For Repair; Electric Check Of The Main Pcb; The Method That Takes Out A Tray; Remove Cd Tray - Kenwood RXD-NV500 Service Manual

RXD-NV500/NV600

Electric check of the main PCB

1) Remove X29(A/3),X29(B/3), and X07(A/7) in order.
(Remove the fan motor assy ,then assemble it on the
heatsink1.)
2) Connect GND between each PCB and the rear panel
with 4 alligator clip wires 2.
3

The method that takes out a tray.

1. Plug thin driver etc.to a square hole. And, press a rack gear
in the direction of an arrow(1).
2. Press the back side of a tray toward an arrow(2) with a fin-
ger. At this time, draw a tray from a front side because a
tray appears on the side of a front.
4

DISASSEMBLY FOR REPAIR

Insulator
1
2
X29
(A/3)
2
X29
(C/3)
X29
(B/3)

Remove CD tray

4
Take notice of the hooks with the
CD tray panel, then remove the
CD tray panel3.
Disassembly the remocon
holder
Take notice of the spring position,
then disassemble the remocon
holder4.
2
2
X07
(A/7)
X07
(D/7)
2
x12
1