Download
Share
Print this page
Binatone DT820N Quick Installation Manual
  1. Manuals
  2. Brands
  3. Binatone Manuals
  4. Network Router
  5. DT820N
  6. Quick installation manual
Binatone DT820N Quick Installation Manual

Binatone DT820N Quick Installation Manual

Wired adsl2+ router
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual

Quick Installation Guide

DT820N
Wired ADSL2+ Router

Advertisement

loading

Related Manuals for Binatone DT820N

Summary of Contents for Binatone DT820N

  • Page 1: Quick Installation Guide

    Quick Installation Guide DT820N Wired ADSL2+ Router...

  • Page 2: Connecting The Router

    Connect the ADSL LINE. Method one: Plug one end of the twisted-pair ADSL cable into the LINE port on the rear panel of DT820N, and insert the other end into the wall socket. Method two ： You can use a separate splitter.
  • Page 3 Attach the power adapter. Connect the power adapter to the POWER connector on the rear of the device and plug in the adapter to a wall outlet or power extension. d. Turn on the DT820N and power on the computers and LAN devices. Figure 1...

  • Page 4: Log In To The Router

    2. Login to the router To connect to the router, you should set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your PC(s). If you need instructions, please refer to the User Guide on the Resource CD. a.
  • Page 5 configure the router using the web browser. Please select the Quick Start tab, and then click RUN WIZARD, the next screen will appear. Click the NEXT button to continue. Figure 3 b. Configure the time for the router, and then click the NEXT button.
  • Page 6 Figure 5 I. If you have a PPPoE/PPPoA account, select PPPoE/PPPoA and click NEXT to configure the following options: Username, Password, VPI, VCI and Connection Type in Figure 6. Then click NEXT. Figure 6 II. If you have a dynamic IP (or an automatic IP) account, select Dynamic IP Address and click NEXT to load the following figure.
  • Page 7 the VPI, VCI and Connection Type in Figure 7, and then click NEXT. Figure 7 III. If you have a fixed IP (or static IP) account, select Static IP Address and click NEXT to load the following figure. Then enter the VPI, VCI, IP parameters and Connection Type in Figure 8, and then click NEXT.
  • Page 8 IV. If you want to set the router as a bridge, select Bridge Mode and click NEXT. Then enter the VPI, VCI and Connection Type in Figure 9, and then click NEXT. Figure 9 d. Click NEXT to finish the Quick Start. Figure 10...