VTech DS6621 Abridged User Manual page 13

When you received a voicemail, the handset displays
retrieve, you typically dial an access number provided by your telephone service
provider, and then enter a security code. Contact your telephone service provider
for instructions on how to configure the voicemail settings and listen to messages.
You can add new cordless handsets (
speakerphone, or speaker box to your telephone system (purchased separately).
Your telephone system supports a maximum of five devices.
Additional devices registered to the telephone system are assigned numbers in the
sequential order. Register each device with the telephone base before use.
When first purchased and properly charged, each expansion handset shows
and
registering it to the telephone base.
To register a DECT 6.0 cordless headset, speakerphone, or speaker box to this
telephone system, please refer to the user's manual of the respective product for
more details. To register a cordless handset, see below.
• Place the new/non-registered handset in the telephone base. The handset
shows
The handset shows
completes. The registration process takes about 90 seconds to complete.
To replace a handset or reassign the designated handset number of a registered
handset, you must deregister all devices and then individually register each handset.
1. Press and hold
until the light on the telephone base flashes.
2. Immediately press
All handsets show
deregistration process completes. The deregistration process takes about
10 seconds to complete.
If you have difficulty with your telephone, please try the suggestions below.
If you cannot find the answer to your question, contact customer service by visiting our
website at
or call
• Make sure you have cellular coverage and the Bluetooth function of your cell phone or headset
is turned on. See the user's manual of your cell phone or headset for more information.
• Make sure that the telephone base is in discoverable mode.
• Carefully follow the pairing instructions on page 6-7. Make sure that your Bluetooth cell
phone or headset is not connected to any other Bluetooth device, and is connected to the
telephone base and active on the device list.
• Remove from your cell phone's handsfree device history list (see the user's
manual of your cell phone for more information).
• Turn off your cell phone or headset, and then turn it on again.
• For some cell phones, you must authorize
feature. See the user's manual of your cell phone for more information.
• Most cell phones have the Bluetooth feature in the connection or setup menus. Please refer
to the user's manual of your cell phone.In general, press the menu key on your cell phone,
and then look for the Bluetooth menu in the settings or connection menu. In the Bluetooth
menu, select the option to search for or add new devices.
• Reset the telephone base. Unplug the unit's electrical power. Wait for approximately 15
seconds, and then plug it back in. Repeat the above suggestions
• Make sure you enter the correct PIN. The default PIN is
• If your cell phone has poor reception in your home, the
reception. However, if there is a location in your house with better reception, you can leave
your cell phone at that location while you use the
the telephone base must be within 30 feet of the cell phone.
and
), DECT 6.0 cordless headset,
alternately. Charge the handset before
Do not place the
handset in the charger.
and you hear a beep when the registration process
on the telephone base for about 10 seconds
again.
and alternately when the
or calling . In Canada, go to
.
device in your cell phone's Bluetooth
.
cannot improve the
cell line. In order for this to work,
13
. To