Turning On The Projector - Philips SV1 User Manual

Positioning the projector and

Turning on the projector

Menu Menu OK OK
Source Auto Image
Source Auto Image
Lamp Temp.
Lamp Temp.
Philips Multimedia Projector
3. Set up
screen
Front projection
Rear projection
• Place the projector on a stable, level surface out of direct sunlight and away from sources of
excessive dust, dirt, heat, water, moisture, vibration and strong magnetic fields.
• Allow sufficient cooling of the product by keeping all air inlets and outlets clear from
obstructions.
• Position the projector in such way that the viewers cannot watch into the projector light beam.
• Choose a screen size suitable for the number of viewers and the size of the room.
• Picture quality is best when you sit directly in front of the projector screen.
• The projector can be used for front projection, rear projection and ceiling projection
applications. As default factory setting, the projector has been set up for front projection.
You can change to rear or ceiling projection via the 'Mirror' function in the 'Setup' menu.
• For more information, check the Projection Assistance application on the Cd-rom.
1 Insert the mains lead into the projector's Mains inlet socket and connect it to the wall socket.
– The Standby indicator light is red indicating the projector is now in the Standby mode.
2 Remove the lens cap.
3 Press the Standby button on the projector or remote control to turn on the projector.
– The Standby indicator light blinks green indicating the projector is now warming up.
– When the projection lamp is on, the Standby indicator light turns green after the start-up
screen has appeared for several seconds.
4 Press the Standby button twice to switch the projector back into the Standby mode.
– The Standby Warning screen will appear for 20 seconds.
– The projector will now go into Standby mode.
5 To switch off the mains supply completely, disconnect the mains lead.
Notes
– Save energy! Please put the projector in the Standby position if you are not going to use the
projector for more than 15 minutes.
– When no signal inputs are detected for 15 minutes, the projector automatically returns to
Standby ('Auto Standby').
– Before disconnecting the mains lead, make sure that the cooling fan has stopped
(about 2 minutes after the projector returned to Standby).
10
SCREEN
Ceiling front projection
SCREEN
Ceiling rear projection
SCREEN
SCREEN
English User guide bCool SV1
>