Philips ProScreen PXG20 User Manual page 33

11. ADDITIONAL INFORMATION
6. Slide the lamp cage cover in.
– Slide the lamp cage cover in the direcrtion of the arrow.
Then fasten the user service screw.
Be sure the lamp timer is reset after replacing the lamp.
If not reset, the projector does not recognize the lamp
replacement and the previous status remains unchanged.
CAUTION!
– Do not remove the lamp cage directly after operation of the
projector. The lamp may be extremely hot. Wait at least one
hour after the powercord is disconnected to allow the
surface of the lamp cage to fully cool before removing the
lamp cage.
– Be sure to remove the lamp cage by the handle. Be sure not
to touch the glass surface of the lamp cage or the inside of
the projector.
Note:
CAUTION!
– To avoid injury to yourself and damage to the lamp, be sure
to carefully follow each steps under 'Replacing the lamp'.
– Before or after replacing the lamp, be sure to clean the air
filters. See page 29 for cleaning the air filters.
Resetting the lamp timer
1. Connect the powercord.
– Plug the powercord into the AC socket of the projector.
2. While pressing 4, 2 and OK on the projector, press Power
ON on the projector.
– 'Lamp 0000H' is displayed, indicating that the lamp timer is
reset.
KENSINGTON LOCK
This projector has a Kensington Security Standard slot for use
with a Kensington Micro Saver Security System. Refer to the
information that came with the system for instructions on how
to use it to secure the projector.
Kensington
Security
Standard connector
Maintenance
) )
31