Table of Contents
Advertisement
3 Initial Operation
EN
Connect power supply /
charge battery
Mains Voltage at the Site of Installation!
Check whether the mains voltage of the
power supply matches the mains voltage avail-
able at the setup location.
1 Insert the small plug of the power supply into the
socket on the rear side of your device.
2 Plug the power supply into the mains.
3 During the charging process, the indicator light on
the top of the device will be red. When the battery
is fully charged, it will turn green.
4 Charge the built-in battery before using for the first
time for at least 3 hours. This will prolong, the life of
the battery.
6
CAUTION!
Initial Installation
1 Switch the device on using the on/off switch on the
side.
2 Turn the device towards an appropriate projection
surface or wall at a distance of at least 0,2m and at
most 3m. Make sure the projector is in a secure
position.
3 Use the focus wheel on the top to adjust the image
sharpness.
4 Select the desired menu language using ¡/¢.
5 Confirm with à.
Notice
The language selection does not ap-
pear
The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1 Press à.
2 Select using ¡/¢ Language.
3 Confirm using à.
4 Select the desired language with ¡/¢.
5 Confirm with à.
6 You can exit with ¿.
Philips · PPX1230
Hide quick links:
Advertisement
Table of Contents
