Sound Volume - Sanyo CPP2510 Instruction Manual

(Remote Control Operation)
Fine tuning
Press
< >
(Fine tuning) button.
C
Press
A
or volume bunon.
quency.
Note: Normally fine tuning is not required forthis TV. However,
in some case (such as radio interference) picture may be-
come more clear by detuning from the best tuned fre-
In such case, you can use this fine tuning to eliminate
some interference beat pattern.
Sound adjustments
To adjustthe sound volume:
Press
A
(up) or
' l
(down)
v o l u m e 0 button.
To adjust the bass, treble, balance and the depth of surround
effect:
Select the control function by pressing AUDIO SELECT@
button.
Each time AUDIO SELECT@ button is pressed, the con-
trol function changes as follows;
- - . . . - . . + - . . . , . . -
--------
+ . . ,
.-..-
-.------
+
----..--
BASS TREBLE BALANCE
A SOUND
SURROUND LEVEL
mmw*m----
SOUND VOLUME
SURROUND
LEVEL
Note: "SURROUND LEVEL" will be skipped when the sur-
round effet is turned off.
4
Adjustthe bass, treble, balance or the depth of surround ef-
fect by pressing Volume
0
button.
@...
Surround ON/OFF
To enjoy the surround effect, press the Surround ONIOFF
@
button.
To cancel the effect, press this button again.
Surround OFF Surround ON
@...
StereoIMono
v
STEREO
. .
When receiving the stereo broadcast, ) r
IS
d~splayed.
If thesound of a stereo broadcast is not clear due to interfer-
ence or poor reception, select the MONO position by press-
ing this button.
In the AV mode, select either STEREO or MONO to match
the stereo or monaural condition of the audio signal coming
from an external source, eg. a VCR, A. V. equipment, or
other component by pressing StereoIMono Switch.
STEREO MONO
@...
Bilingual AIB
When receiving the bilingual broadcast,
MA'NiA'
is dis-
played.
)Id
You can select the main or sub language with this button.
In the AV mode, each time Bilinaual A/B button is pressed, the
-
audio channel changes as follows:
LEFT ( A ) - - R I G H T (B)
@....Sound mute
Should you wish to mute the
sound 1e.g. While talking on the
telephone), press this button once.
To switch the sound back on,
press it again.
(D...
Normalization
-+C
Press this button to recall the pic-
ture and sound settings which
you stored using the Memory
0
button.
A SOUND
MUTE
@....
Channel Scanning
0
Press Channel Scanning bunon @to search for a programme.
The channel positions are automatically scanned, and the chan-
nel scanning will stop at the position where
it
began. To stop at
the position you want, press this button again.