Important Note - Sanyo CPP2510 Instruction Manual

(TELETEXT USE)
Time
Coded
Pages
(TIMUSUB)
@
Time coding enables the viewer to put into store a specific
page of information ready for viewing at a pre-determined
time.
IMPORTANT NOTE
With present transmissions this facility is limited to the
'Alarm Clock' pages. Please refer to the transmitted index
for the appropriate page number.
The required page is selected in the usual manner and then
the command T. PAGE (Time Page On) is entered. The time
,~~~
~~.~
~ ~~ ~
that the requested page should be received is then entered
on the screen using the number keys two digits for hours
and two digits for minutes. using the 24 hour clock system.
The character
7'
precedes the time digits to indicate that a
time code and not the actual code is being displayed, also
the four digits flash. After the time code has been entered
rolling page numbers are presented. The cancel button is
then pressed and the receiver reverts to picture. When the
pre-set time is reached the page number will appear in the
top left corner of the screen and the data can be seen by
pressing cancel again. To clear the time code from the T.V.
memory, press TlMElSUB
@
button again. (Time Page
m.
it is important to remember that once the time coding has
been set and the text cancelled pressing any buttons on the
handset other than the Brightness, Colour, Volume and
Mute may upset the pre-set time.
, , ,
. , . ,
~
,~...
TIME
If the time is required while a programme is being viewed
press the TlMElSUB
@
button.
Providing that the channel being viewed is also transmitting
teletext, the time will appear a t the top righthand of the sc-
reen for five seconds. The digits displayed represent hours1
minuteslseconds.