Installing The Vka05 Ops Module - Vivitek NOVOTOUCH LK6530i User Manual

Installing the VKA05 OPS Module

Before you begin using the display it is suggested that you install the VKA05 OPS
Module first. If you do not install the VKA05 OPS module before you begin using the
display, the display will not have all the functions available for use. To install the VKA05
OPS module follow the instructions below:
1. Remove the 2 screws securing the slot cover onto the
display, and then remove the slot cover.
2. Slide the OPS module into the OPS slot.
3. Tighten the two captive screws on the OPS module
until the module is properly secure in the display.
4. Install the antenna onto the connector on the OPS
module.
Copyright © 2017 Vivitek. Vivitek is a trademark of Delta Electronics, Inc.
NovoTouch User Manual
Page 19